6
Instruction manual
Specifications
Supported formats
CDDA/MP3
Supported storage
CD/CD-R/CD-RW/USB/SD/MMC
Power supply
220 V, 50 Hz (6хUM2 batteries)
Output power, RMS
4W x 2
FM frequency range
64 - 108 MHz
AM frequency range
522 - 1620 kHz
Net/Gross weight
2.82 kg/3.25 kg
Unit dimension (L x W x H)
390 mm x 248 mm x 182 mm
Gift box dimension (L x W x H)
408 mm x 270 mm x 204 mm
Specifications and functions are subject to change without notice. It is connected with continual
improvement of the device.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• The heads and capstan are in constant
contact with the moving tape. Use a small
cotton bud with alcohol or special tape head
cleaner to clean these parts. Never touch the
heads with anything metallic.
• When pick up the CD disc, always hold the
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
Erase protection
• To prevent accidental erasing of a
cassette, simply break off the two plastic tabs
located on the cassette tape’s rear side.
• When a cassette with removed plastic
tabs is inserted, the recording button cannot be
pressed.
• If a cassette is to be erased and re-
recorded at a later stage, simply cover the
holes on the cassette where the tabs were
removed, with a piece of strong adhesive tape.
Accessories
Radio player
1 pc
Power cable
1 pc
Instruction manual
1 pc
Warranty card
1 pc
Consumer information
1 pc
