Hyundai CUT- 401, User Manual

Page: 8 / 16

06
5. Installation Debugging and Operation
Input cable connection (enclose installing diagram)
1) Every machine has been equipped with a power cable which must be connected to coordinate voltage
class in compliance with input voltage of cutting machine.
2) Make sure power cable is connected to power switch reliably and prevent from oxidizing. Make sure power
voltage is in the waved range.
Output cable connection
1) Make sure tube of pressed air is connected to copper connector by high pressure rubber tube fiITnly.
2) Make sure copper screw of another end of torch is connected to electrify integrated teITninal and then
tighten them clockwise (to prevent from leaking gas). Make sure plug of another end of grounding cable
pincer is connected to positive terminal on front panel then tighten it.
3) Make sure air plug of torch is connected to switch connector of panel (If it is arc-supporting cutter, arc-sup­
porting cable of torch is connected to teITninal of arc-supporting).
Check
1) Check if cutting machine is grounded reliably according to standard.
2) Check if all connectors are connected firmly.
3) Check if power voltage is correct.
Operation
1) Open the power switch of front panel, make the power switch is "on" position. At this time indicator of
power switch is on. Screen will show the current volume.
2) Adjust the gas pressure and make it adequate to machine, open the valve of pressed air.
3) Press the control knob of torch, electromagnetic valve is starting, sound of HF arc-tricking can be heard
and burner of torch should flow out gas (Burner of arc-supporting cutter should spurt fire)
4) Make sure cutting current is adequate to machine according to thickness of cutting piece.
5) It is I mm from copper tip to work piece
Ot
is further if it is arc-supporting cutter.), press knob of torch and
strike arc. Sparks of HF arc-striking will diminished immediately .User can begin to cut.
Instruction Notes
Operation environment
1) The cutting machine can perform in environment where conditions are particularly harsh and with outside
temperature between -10 and +40 degrees Celsius with a dampness level of max 80%.
2) Avoid using in sunshine and rainy environment.
3) Keep machine dry and avoid water into machine.
4) Do not use the cutting machine in environment where is polluted with high density of dust or corrosive gas
in the air.
HYUNDAI
CUT- 401