Hyundai 2007 Sonata Owner'S Manual Download Page 98

Page: 98 / 283

FEATURES OF YOUR HYUNDAI

Standard Programming

To train most devices, follow these instructions:
1. For first-time programming, press and hold

the two outside buttons, HomeLink

Channel

1 and Channel 3 Buttons, until the indicator
light begins to flash (after 20 seconds).
Release both buttons. Do not hold the but-
tons for longer than 30 seconds.

2. Position the end of your hand-held transmit-

ter 1-3 inches (5-14 cm) away from the
HomeLink

buttons while keeping the indica-

tor light in view.

3. Simultaneously press and hold both the

HomeLink

and hand-held transmitter but-

ton. DO NOT release the buttons until step
4 has been completed.

4. While continuing to hold the buttons the red

Indicator Status LED will flash slowly and
then rapidly after HomeLink

successfully

trains to the frequency signal from the hand-
held transmitter. Release both buttons.

5. Press and hold the just-trained HomeLink

button and observe the red Status Indicator
LED. If the indicator light stays on constantly,
programming is complete and your device
should activate when the HomeLink

button

is pressed and released.

6. To program the remaining two HomeLink

buttons, follow steps 2 through 5.

Rolling Code Programming

Rolling code devices which are "code-pro-
tected" and manufactured after 1996 may be
determined by the following:
o Reference the device owner's manual for

verification.

o The handheld transmitter appears to pro-

gram the HomeLink Universal Transceiver
but does not activate the device.

o Press and hold the trained HomeLink button.

The device has the rolling code feature if the
indicator light flashes rapidly and then turns
solid after 2 seconds.

To train rolling code devices, follow these in-
structions:
1. At the garage door opener receiver (motor-

head unit) in the garage, locate the "learn" or
"smart" button. This can usually be found
where the hanging antenna wire is attached
to the motor-head unit. Exact location and
color of the button may vary by garage door
opener brand. If there is difficulty locating the
training button, reference the device owner's
manual or please visit our Web site at
www.homelink.com.

2. Firmly press and release the "learn" or

"smart" button (which activates the "training
light").

NOTE:

There are 30 seconds in which to initiate
step3.

3. Return to the vehicle and firmly press, hold

for two seconds and then release the de-
sired HomeLink

button. Repeat the "press/

hold/release" sequence a second time to
complete the programming. (Some devices
may require you to repeat this sequence a
third time to complete the programming.)

4. Press and hold the just-trained HomeLink

button and observe the red Status Indicator
LED. If the indicator light stays on constantly,
programming is complete and your device
should activate.

5. To program the remaining two HomeLink

buttons, follow either steps 1 through 4
above for other Rolling Code devices or
steps 2 through 5 in Standard Programming
for standard devices.

Gate Operator & Canadian Programming

During programming, your handheld transmit-
ter may automatically stop transmitting. Con-
tinue to press the Integrated HomeLink

Wire-

less Control System button (note steps 2 through
4 in the Standard Programming portion of this
document) while you press and re-press
("cycle") your handheld transmitter every two
seconds until the frequency signal has been
learned. The indicator light will flash slowly and