![background image](http://html.mh-extra.com/html/hyundai/110d-9/110d-9_manual_2196420215.webp)
7-46
A
B
C
D
C
E
F
Outside
110D9MI53
110D9MI54
73036MI26
110D9MI55
MAINTENANCE OF WORK EQUIPMENT
Lubricate to each point of working device.
Lubricate the grease to grease nipple in
accordance with lubrication intervals.
Shorten lubricating interval when working in the
water or dusty place.
ö
Check for wear and tear of work equipment pins
and bushings.
Check for damage of forks and mast linkage
part.
Check daily and lubricate the fork positioner
hanger bar and bottom plate where the fork is
c o n t a c t e d , o r t h e f o r k s m a y v i b r a t e
temporarily while positioning.
Dust seal are mounted on the rotating part of
working device to extend the lubricating interval.
Mount the lip to be faced out side when
replace the dust seal.
If it is assembled in wrong direction, it will
cause fast wear of pin and bushing, and
create noise and vibration during operation.
Make sure the seals are not damaged or
deformed.
37)
(1)
(2)
(3)
ö
(4)
ö
ö
ö
WORK EQUIPMENT SUPPORT
When carrying out inspection and maintenance
with the forks raised, fit a stand under the forks
securely to prevent the work equipment from
coming down. In addition, set the work equipment
control levers to the Hold position.
38)
No.
Description
Qty
A
Fork adjustment cylinder pin
2
B
Fork shaft
1
C
Tilt cylinder pin
2
D
Load chain
2
E
Mast support pin
2
F
Chain sheave pin
2