4
Note: Unless otherwise specified, the
PTT key mentioned in this manual
indicates that of the palm microphone.
Installation
Instructions
Before you install the radio in a vehicle, be sure to read
the following instructions carefully:
●
The radio must work with a13.6V
±
15% negative
ground electrical system only. Ensure to check the
ground polarity and voltage of the vehicle power
supply prior to installation.
●
Install the radio in a location where you can reach
the front panel conveniently.
●
Check how long the screws will extend from the
bottom surface of the radio before installation. Drill
the mounting hole cautiously to avoid damage to
the vehicle wiring and other parts.
●
Install the radio with mounting bracket supplied by
the Company, to avoid radio looseness in case of
accidents. The loose radio may cause bodily injury.
●
Connect the antenna and power cord to the radio
before you install it in the bracket. And make sure
the antenna and power cord are dedicated for
digital radios of the Company.
●
Keep sufficient clearance at the back of the radio
for wiring.
●
Be sure to use the fuse with the same specification
for DC power cord upon replacement.
●
If there are any other device in the vicinity of this
radio, the distance between the antenna of this
radio and the antenna of such RF device shall be
no less than 10 meters.
Installation Tools
●
Electric Drill
●
Cross head screwdriver
●
Hex socket sleeve (for 4.8 * 20mm self-tapping
screws)
Installation Parts
No.
Part Name
No.
Part Name
1
Radio
8
Power Inlet
2
Locking
Knobs
9
P o w e r C o r d
(black)
3
Mounting
Bracket
10
Power Cord (red)
7
6
4
2
12
1
11
10
9
8
13
5
3
No.
Part Name
No.
Part Name
4
4.8 * 20mm
Self-tapping
Screws
11
Fuse
5
Palm
Microphone
12
R F A n t e n n a
Connector
6
4 * 16mm
Self-tapping
Screws
13
G P S A n t e n n a
Connector
7
Microphone
Hanger
/
/
Installation Procedure
1. Install the
bracket
in a location where you can
operate the radio conveniently.
2. Connect accessories such as the
antenna
and
power cord
to the radio.
3. Slide the
radio
into the properly mounted bracket
and secure it using the locking knobs.
4. Install the
microphone hanger
in a location where
it can be reached easily.
5. Plug the
palm microphone
connector into the
radio, but at first align the triangle index on the palm
microphone with the microphone installation index.
Place the palm microphone on the hanger when
you do not use it.
