10
HYT SA - Route des Falaises 74
2000 Neuchâtel - Switzerland
Phone + 41 32 323 27 70
www.hytwatches.com
C
B
SETTING THE TImE
Pos C.
10 minutes = 1 crown movement
= 1 sec of manipulation
INTRODUCTION
This function allows the time shown on your watch to be set using the crown.
IMPORTANT
• Moving the microfluids within the capillary
3
should be approached with as much
caution as setting a perpetual calendar or a minute repeater
• We highly recommend that the fluid is only moved 10 minutes with each movement
of the crown
• This should mean that moving the fluid a full hour takes no more than 12 seconds.
HOW TO USE
• Unscrew the crown and pull it out to position “C”
• Then turn the crown in either direction until the coloured liquid (hour display) and the
minute hand is at the time required
• Push the crown in completely against the case
• Do not forget to screw in the crown completely to ensure its water resistance.
RETROGRADE
• The automatic return of the coloured liquid
(retrograde)
4
is allowed by the pressure of the two
bellows
2
. The speed is higher when the retrograde
4
starts in “Zone II” and is minimal when the liquid
approaches its starting point in “Zone I”.
Zone I
Zone II
