9.
Remove cotter pin from end of pivot pin. Remove
grease fitting if necessary. See Figure 7.
10.
Using a brass drift and hammer, remove pivot pin from
swivel and control arm. See Figure 7.
NOTE:
Make sure control handle wiring is disconnected/
removed before removing control arm from swivel.
11.
Separate control arm from swivel. See Figure 7.
12.
Inspect bushings for excessive wear, remove from con-
trol if necessary.
Install
Refer to Figure 7 for the following instructions.
1.
Install bushings into control arm.
2.
Position control handle to swivel. Install pivot pin into
control arm and swivel.
3.
Install cotter pin into pivot pin. Install grease fitting if
removed.
4.
Reconnect control handle wiring as removed. Refer to
tags for proper identification. Install wire ties as re-
moved to secure control handle wiring to main harness.
NOTE:
Be careful not to damage the brake switches when
installing the gas spring.
5.
Install the gas spring. Refer to Gas Spring in this sec-
tion.
1. SWIVEL
2. STUD
3. NUT
4. CAPSCREW
5. GREASE FITTING
6. BUSHING
7. PIN
8. CONTROL ARM
9. CAP
10. GAS SPRING
11. BALL STUD
12. SCREW
13. NUT PLATE
14. BRAKE SWITCHES
15. COTTER PIN
Figure 7. Control Arm Mounting (Power Assist Steering)
Control Handle
1600 SRM 1637
8
