Install (Complete Unit)
1.
Using the overhead lifting device, carefully position
the steer support to the frame. Align the holes in the
steer support with mounting holes in the frame. See
Figure 17.
2.
Install the four capscrews, washers, and nuts securing
the steer support to the frame. Tighten to
88 N•m (65 lbf ft). Remove the sling and lifting de-
vice.
3.
Connect the control handle wiring harness, the brake
switch, and the sensor from the main wiring harness as
noted. Install a new wire tie securing the harnesses to
the main harness as removed.
4.
Reconnect wiring to the BDI display and key switch if
removed. Align the slots in the dash with the retaining
screws and position the dash to the steering support
and frame. Tighten the two screws to secure the dash
assembly in place. See
Electrical System
2200SRM1640.
5.
Position the cover onto the steer swivel. Install the
three screws securing the cover in place.
6.
Install the drive unit compartment covers as removed.
Connect the battery and turn the key switch to the
ON
position. Test for proper operation.
1. WIRE SLEEVE
2. BEARING NUT
3. LOCKING WASHER
4. SPACER
5. UPPER BEARING
6. SWIVEL
7. CENTER SUPPORT
8. LOWER BEARING
9. STEER SHAFT
10. CAPSCREW
11. NUT
12. STEER PLATE
Figure 16. Steer Support (Standard Steering)
Steer Support Assembly
1600 SRM 1637
18
