86
MAXPRO200
Instruction Manual 807700 Revision 1
Operation
Varying the gouge profile
You can vary the gouge profile and the metal removal rate by varying the speed of the torch over the workpiece, varying
the distance between the torch and the workpiece, varying the angle of the torch to the workpiece, and varying the
current output of the power supply.
The following actions have the stated effects on the gouge profile:
•
Increasing the speed
of the torch will
decrease width
and
decrease depth
.
•
Decreasing the speed
of the torch will
increase width
and
increase depth
.
•
Increasing the standoff
of the torch will
increase width
and
decrease depth
.
•
Decreasing the standoff
of the torch will
decrease width
and
increase depth
.
•
Increasing the angle
of the torch (more vertical) will
decrease width
and
increase depth
.
•
Decreasing the angle
of the torch (less vertical) will
increase width
and
decrease depth
.
•
Increasing the current
of the power supply will
increase width
and
increase depth
.
•
Decreasing the current
of the power supply will
decrease width
and
decrease depth
.
Cutting parameters
The cut charts for the MAXPRO200 show the consumable parts, cutting speeds, and the gas and torch settings required
for each process, allowing for differences in the lead length. These parameters are used for cutting with both mechanized
and handheld torches, the consumable part numbers listed with each cut chart are specific to mechanized torches. Refer
to
below for the consumables to use with handheld torches.
The cut chart values in this document are recommended to provide high quality cuts with minimal dross. Because of
differences between installations and material composition, adjustments may be required to obtain desired results.
Mechanized consumables
The consumable part numbers listed above each cut chart are specific to mechanized torches.
Hand held torch consumables
The following sets of consumables are intended to be used with handheld torches for cutting mild steel, stainless steel,
and aluminum. Use the cutting parameters detailed in the
for cutting with the MAXPRO200 handheld torches.
Use the following consumables for each process.
Summary of Contents for MAXPRO200
Page 1: ...MAXPRO200 Instruction Manual 807700 Revision 1 ...
Page 26: ...22 MAXPRO200 Instruction Manual 807700 Revision 1 Safety ...
Page 34: ...30 MAXPRO200 Instruction Manual 807700 Revision 1 Product Stewardship ...
Page 38: ...34 MAXPRO200 Instruction Manual 807700 Revision 1 Specifications ...
