Hypertherm Abrasive pot, Instruction Manual

Page: 29 / 36

Abrasive pot
Instruction
Manual 809080 29
Tr
o
ubleshooting
Section 5
Troubleshooting
Safety
Abrasive flow can be limited or stopped by a variety of causes.
The pot is empty
When the pot is empty, the feed hose fills with air and the abrasive does not flow.
Fill the pot. Refer to
Fill the pot with abrasive
on page 27 for instructions.
Abrasive blows out of the top of the regulator
1. Make sure that there is enough abrasive in the pot. When the abrasive level is low, air can flow past the abrasive
and blow abrasive out of the top of the regulator. Refer to
Fill the pot with abrasive
on page 27 for instructions.
2. Make sure that the pot pressure is correct. If the pressure is too high, air can blow through the abrasive. Refer
to
Adjust the pot pressure
on page 27 for instructions.
Refer to the instruction manual. Read and understand all of the safety guidelines in this manual.
Examine and clean the equipment regularly. Make repairs immediately.
Follow all safety requirements and applicable safety laws and regulations.