Hypertherm Abrasive pot, Instruction Manual

Page: 30 / 36

30 Abrasive pot
Instruction
Manual 809080
5 – Troubleshooting
Tr
o
ubleshooting
The abrasive is contaminated
Debris such as pieces from the abrasive bags can block the feed hose. Wet abrasive can also block the feed hose.

Prevent humidity in the abrasive with an air dryer on the compressed air source.
1. Close the ball valve. Pressurized air escapes through the muffler.
2. Disconnect the feed hose from the bottom of the abrasive pot. Direct the abrasive into a container.
3. Inspect the abrasive and the pot for moisture and debris. Discard contaminated abrasive. Refer to
Recycling
and end of product life
on page 36.
There is water in the regulator bowl
The liquid level indicator on the air regulator displays the water level in the air regulator bowl.
1. Turn off the compressed air source.
2. Twist the drain handle 90° to open the drain.
3. When the bowl is empty, twist the drain handle 90° to close the drain.
2
1
3
4
5
1 Air regulator bowl
2 Liquid level indicator
3 Drain handle
4 Drain open
5 Drain closed