Hypertherm Abrasive pot, Instruction Manual

Page: 34 / 36

34 Abrasive pot
Instruction
Manual 809080
6 – Installation
Inst
allation
Requirements
Location
 Install the pot near the work area but away from sources of moisture.
 To provide access for filling, install the pot near one of the front legs of the cutting machine.
 Make sure that there is a minimum clearance of 91 cm (36 inches) on all sides of the abrasive pot to permit
room for maintenance and repair.
Air
The recommended air pressure is 40 psi.

Prevent humidity in the abrasive with an air dryer on the compressed air source.
Electrical power

The low-level sensor requires a 115 V outlet.
Connect the abrasive regulator to the pot
Unload the pump

A hose clamp can be used to secure the hose to the fitting.
1. Connect the feed hose to the hose barb on the bottom of the abrasive pot.
2. Refer to the abrasive regulator manufacturer’s instructions to attach the other end of the feed hose to the
regulator.
DANGER
To reduce the risk of electrical shock, the incoming power supply must include a protective earth
ground.
The feed hose should have minimal elevation changes. Do not install the feed hose higher than 3.05 m
(10 feet) above the floor.
The abrasive regulator should be mounted before connecting the abrasive pot to it. Refer to the
abrasive regulator manufacturer’s instructions.