HYOSUNG Aquila Classic, Owner'S Manual

Page: 67 / 94

CAUTION
66
1. Place the motorcycle on the jack or block.
2. Loosen the rear axle
①
.
3. Loosen the lock nut
②
, right and left.
4. Adjust the slack in the drive belt by the
drive belt adjuster
③
, right and left, as
turning toward the clockwise or counter-
clockwise.
5. Inspect the drive belt slack by the belt
case inspecting hole
⑤
at the left side of
the motorcycle.
6. For alignment of the front wheel and
rear wheel, there are reference mark
④
on the same position, right and left.
Aligning and adjusting the slack in the
drive belt to specification, retighten the
lock nut and rear axle securely and per-
form a final inspection.
4.5 ~ 5.5 mm
(0.18 ~ 0.22 in)
When the rear tire be
touched the ground
5.0 ~ 6.0 mm
(0.20 ~ 0.24 in)
When the rear tire be not
touched the ground
DRIVE BELT SLACK (4.5 kgf of Force)
⊙
DRIVE BELT SLACK ADJUSTMENT
Adjust the drive belt slack to the proper
specification. The belt may require more fre-
quent adjustments than periodic mainte-
nance schedule depending upon your riding
conditions.
Adjust the belt in the following way.
The two pulleys should be inspected for
wear when a new belt is installed and
replace them if necessary.
●
Broken or damaged teeth
● Loose pulleys mounting nuts
If you find any of these problems with
your pulley, consult your Hyosung dealer.
See Table
Engine pulley
Rear pulley
Belt case
inspecting hole
4.5 kgf of Force
❷
❸
❶
❺
❹