HygroMatik MiniSteam MS 10, Manual

Page: 36 / 46

Page 36
8.6 Cleaning the Blow- Down Pump
» Remove cylinder, as described in Section: "Removing
and Cleaning the Steam Cylinder” .
» Detach e-cable from the pump.
» Detach adapter (30) from the pump.
» Loosen screws (44) and remove the pump from the
base.
» Open the pump (bayonet lock).
» Remove residues from the drain hoses and pump
(potentially replace o-ring (33) or housing (34) if these
components are no longer in excellent condition).
» Reassemble the pump.
» Moisten o-ring (31) and insert in the side connection of
the base.
» Push pump into the base and mount tightly with screws
(44).
» Moisten o-ring (31) and insert in adapter (30).
» Fit adapter (30) over the side connection of the pump.
» Connect e-cable to the pump.
» Inst all cylinder,
» Switch on the unit and check for leaks during operation.
If leakage occu rs, switch of f power su pply and follow safety
instructions for work on live components.
8.7 Cleaning the Water Inlet Solenoid Valve
Removal
» Shut off water supply.
» Remove cylinder, as described in Section: "Removing
and Cleaning the Steam Cylinder” .
» Loosen water installation hose connection.
» Loosen connecting hose (21) from the base.
» Detach e-cable from the solenoid valve.
» Loosen solenoid valve mounting screws (28).
» Remove solenoid valve from the borehole.
» Remove fine mesh filter (29) from the solenoid valve,
clean and replace if needed.
Installation
» Insert fine mesh filter (29).
» Place solenoid valve with seal in the borehole of the