10
Step 4
- Connect spaside to an empty
connection marked MAIN. (Fig.4)
*Must align Locking Clip on spaside plug with
Locking Tab on circuit board for proper
function.
Locking Clip*
Locking Tab*
Spaside
Plug
Fig.4
When utilizing a spaside
extension cord, the clip and
tab must also be aligned at all
connections.
Fig.5
Fig.5
Cord plugs are labeled to insure proper
plug alignment as shown in
Fig.6
Fig.6
Front side
Back side
CONNECTING SPASIDE & EXTENSION
SPASIDE CONTROL INSTALLATION
Step 1
- Clean area and insert spaside
control. (Fig.1)
Overlay may vary
Step 2
-
Remove the double sided adhesive
from the back of the spaside. Make certain the
spaside is straight and adhere to the spa shell.
(Fig.2)
Ÿ
The mounting area must be above the maximum water level of the spa and in an area with good
drainage to prevent any standing water on or around the spaside.
If required, you may have to cut out a hole in the spa shell to install spaside control.
Ÿ
The spaside should never be submerged.
Ÿ
The spaside should be protected from extended periods of exposure to sunlight.
Step 3
- Remove protective film from display
window then clean the face of the spaside.
Now carefully align and apply the label. (Fig.3)
Fig.3
Fig.1
Fig.2
CAUTION:
Damage may occur to the circuit board and spaside if the spaside plug
is not properly aligned to the receptacle on the circuit board or if the spaside plug
is connected or disconnected while the power is on.
**Any resulting damages are not covered under manufacturer’s warranty**
