2
www.hydrofarm.com
Putting together the Fan SuPPort
1. Open the box and remove plastic from stand base and adjustable shaft.
2. Find and open the hardware bag.
3. Match the four holes on the shaft to the four holes on the stand base.
4. Tighten shaft down firmly with four B bolts.
5. Remove collar from shaft (loosen counterclockwise and slide off).
6. Slide on the bolt cover (comes in hardware bag).
7. Reinstall collar.
Mounting the Motor and Fan
1. Remove cardboard and plastic wrap from the fan motor.
2. Mount the rear fan blade cover to the motor by matching the four holes on the fan blade
cover to the four holes on the motor housing. NOTE: The small bolt on the rear cover
should be at the bottom (facing the base), and the handle on the rear cover should be at
the top.
3. Insert fan blade onto motor drive-shaft. Match the set screw on the fan blade to the flat
spot on the drive-shaft and tighten the screw. NOTE: Make sure the side of the blade with
the set screw is facing forward.
4. Test the fan blade by rotating it with your hand. Make sure it doesn’t contact the fan blade
cover at all. It should rotate freely. Repeat step 2 if the blade doesn’t spin freely.
5. Mount the front fan blade cover onto the rear cover by matching the hole on front cover
with the small bolt on rear cover. Then secure all five clips and tighten the small bolt.
6. Loosen collar on shaft and fully extend. Tighten collar.
7. Loosen bolt below motor housing so that shaft can be inserted. Once inserted, tighten the
bolt to secure.
8. Fan height can be adjusted by loosening/tightening the collar on the shaft.
adjuSting the SettingS
The bottom dial on the fan is the fan speed adjuster. There are four fan speed settings: off (0),
low (1), med (2) and high (3).
The knob on the motor controls the oscillation. Lift it up completely to stop oscillation.
When the fan is in on position, you may hear a very faint timer-like clicking noise, even though
the timer itself is not set.
INSTRUCTION MANUAL
Summary of Contents for Active Air ACFP18
Page 11: ...11 ...
