Page 7
Hydro Systems Europe 2018
5.2.1.
Connect incoming water supply to EvoClean using fittings provided. This will either be a ¾’’ Female BSP swivel, or
15mm push-fit. Ensure the incoming water supply hose is supported so as not to create unnecessary force on the inlet.
5.2.2.
It is a legal requirement, if the unit is supplied from the water mains, that a backflow device is installed offering protection
equal or higher than the chemical class being used. This is to prevent back siphoning of non-potable substances into
the water mains.
Note:
It is possible to have the water inlet on either side of the dispenser but the outlet will always need to be on the right.
Water Outlet
Water Inlet
5.2. Installation Step 2: Incoming Water Supply
5.2.3.
Hose sets used to connect the EvoClean to the mains water supply must also be compliant with IEC 61770.
Note:
It is recommended that the delivery hose between the EvoClean and the washing machine be as short as possible. Any
vertical routes should be kept to a minimum.
5.3.1.
Connect outlet (see above) to the washing machine using 12.7mm (½’’) or 13mm ID Flexible braided PVC Hose.
5.3.2.
Secure PVC hose to barb with cable tie.
5.3. Installation Step 3: Route Discharge Hose to Machine
Check Valves
5.4. Installation Step 4: Routing Pickup Tubes
Note:
The check valves are supplied detached in a bag with the unit. To prevent damage, do not install hoses to the check
valve while connected to the manifold.
