Hydro-Logic Purification Systems EVOLUTION-RO1000, Installation And Maintenance Manual

Page: 8 / 16

NOTE: Make sure the tubing is pushed past the O-rings for a
secure fit. Also, when replacing any tubing, cut tubing
back ~1/4 inch prior to re-inserting to prevent leaks.
INSTALLATION cont.
Step 3: Make Tubing Connections
The connections to the faucet should be complete, the remaining
connections are:
Feed connection—white 1/2” tubing from feed fitting or feed •
valve to pressure gauge and then to white elbow connector
Drain connection—black 3/8” tubing from green elbow
•
connection will attach to the optional drain adapter or be
directed to appropriate drain location
Purified water connection—blue 3/8” tubing blue elbow
•
connection to reservoir or tank via optional 3/8” float valve
Attach the fittings to the manifold
•
A typical connection is shown in Figure 7 Side View and Cutaway of
Tubing Fitting.
NOTE: For optimal system performance, we recommend using tubing
lengths that are as short as possible.
Feed Pressure Gauge w/ "T" fitting
The supplied pressure gauge should be connected to the feed line to
monitor system feed pressure. For proper system performance, the
inlet feed pressure must be between 40 psi (2.76 bar) and 80 psi (5.52
bar) when the system is in operation. Insert the short length of tubing
into the white elbow connector. Then install pressure gauge w/ “T”
fitting. Then install long length of white tubing to other end of pressure
gauge “T” fitting.
Inline Shut-off Valve
The supplied 3/8" inline shut-off valve is designed to be installed on
the blue pure water line. Thje system can be shut-off by using this
valve.
Step 4: Install RO Assembly
The RO Assembly includes the following components: sumps (3),
support leg, carbon pre-filter, and RO membrane elements (2). The
tubing is attached to the manifold by the elbow connectors. When
choosing a location for the system, allow enough tubing for it to be
moved for periodic servicing of the pre- filter and membrane elements
(Figure 8 RO Assembly).
WARNING:
Do not attempt to mount/hang the system. Do not
try to drill mounting holes anywhere on the system.
If putting above ground/cabinet level, a sturdy,
permanent shelf is recommended.
O-Ring
O-Ring
Collet
Tubing
Collet
Lock Clip
Side View and Cutaway of Tubing Fitting Figure 1
RO Assembly Figure 2
Support Leg
RO
Membranes
Prefilter
Sumps
Manifold
Elbow
Connectors
7