10
HGM-C LSHT Wheel Motor
CHECK VALVES
Disassembly
1. Remove castellated nut (1), woodruff key
(6), plastic plugs (8), retaining ring (2),
seven screws (22), seven washers (23), end
cover (19), gearwheel set (17) with O-rings
(16, 18), cardan shaft (15), distributor plate
(14), O-ring (13), output shaft (7) needle
bearing (12), And, from the output shaft
— remove ball bearing (3), washer (4), and
output shaft seal (5).
See pages 4 - 9.
2. Remove the check valves (11) with a ground
3.5mm screw tap.
See figure 15.
The check
valves are pressed in and can be removed
by pulling on the tap.
Inspection
1. Inspect for wear or damage.
Figure 15, Check Valves
Check Valve (11)
