HGM-C LSHT Wheel Motor
13
Pressing Tool
Housing (9)
Output Shaft (7)
Commutation Slot
Front
Annular
Channel
Assembly
1. Mount seal (5), washer (4), and ball bearing
(3) onto output shaft (7).
See page 11.
2. Install check valves (11), and needle bearing
(12).
See page 12.
3. Rotate the motor housing (9) so that the
front (output shaft end) is pointing upward .
See figure 7.
4. The rear of the output shaft (7) must be
marked before fitted into motor housing
(9). The mark must be positioned vertically
above a commutation slot leading up to the
front annular channel.
See figure 8.
5. Grease the journals with hydraulic oil.
6. Position output shaft (7) over motor hous-
ing (9) and carefully lower into the motor
housing (9). Press the output shaft with ball
bearing, washer and seal into motor hous-
ing.
See figure 9.
OUTPUT SHAFT
Figure 7, Motor Housing
Figure 8, Output Shaft
Figure 9, Output Shaft/Press Tool
