Hyd-Mech S20 SERIES III, Manual

Page: 30 / 50

3.6
4. If the blade touches the square at the bottom loosen the top fixing screw “A” and tighten screws “B” the same
amount until the square edge contacts the blade uniformly along the whole blade width. If contact is at the top of
the square, loosen the bottom fixing screw “A” and tighten screws “B” the same amount until the square edge
contacts the blade uniformly along the whole blade width.
5. Position the square on the clean work surface of the infeed table against the blade close to the movable guide
block at a point where the blade teeth do not prevent contact.
6. Repeat step 4 to adjust the movable guide block.
BLADE BRUSH ADJUSTMENT
The machine leaves the factory with the blade brush adjusted for maximum life of the brush. This setting places the ends
of the blade brush wires so as to contact the blade at the bottom of the blade gullets. The plastic drive wheel that is driven
by the drive wheel face should be held against the wheel face with the minimum force that is necessary to ensure brush
rotation. As the blade brush wears it is necessary to periodically adjust it closer to the blade or if a new brush is installed,
further away from the blade.
A
B
C
Infeed Table
Moveable Guide Block