Hyd-Mech H-14P, Manual

Page: 21 / 90

2.5
fUnCTIon bUTTon DEsCRIPTIons
If a red indicator light above a function button is illuminated, it means that the function printed in red at the top of the but-
ton is enabled. No light indicates the function printed in black at the bottom of the function button is enabled. The following
are the function keys for AUTO and MAN modes:
AUTO MODE No function.
MAN MODE If pressed and held in for a few seconds, the HEAD HOME cycle will be initiated.
NOTE: Before using AUTO MODE, it is necessary to “HOME THE HEAD”. This must
be repeated any time the hydraulic system has been shut down so the machine
knows where its HOME position is. While the head fast approach can be used dur-
ing this operation, it is recommended the lever be released so that the head meets
it home position gently.
AUTO / MAN MODE This button will toggle between MAN and AUTO modes. Auto mode cannot be ac-
cessed unless the vise is closed.
Also used to stop an automatic job in progress by switching to MANUAL mode.
AUTO MODE No function, both keys.
MAN MODE Used to access the PARAMETERS. When these two keys are pressed simultaneously,
the display will change to the password (# obtained from Hyd·Mech) screen before the
parameters are displayed. The vise must be closed and the PLC in “INCH” to access the
parameters. To exit the “PASSWORD” back to “MAN”, press or To exit the
“PARAMAETERS” mode, press at any time.
NOTE: Consult the Hyd-Mech Service department before entering the parameters.
AUTO MODE No function.
HOME
AUTO
MAN
P
AUTO
MAN
METRIC
INCH
MAN MODE No function.
AUTO / MAN MODE This button toggles to allow values to be displayed either in millimeters or inches
and the blade speed in either surface feet per minute or meters per minute. It
METRIC
INCH