6
Figure B
4. Carefully slide the chassis into the sleeve.
Ensure that the ground wire is not pinched
or in the path of the condenser fan.
5. Loosen locking plate screw and rotate tab
with tab behind wall case flange (See Fig.
C), then tighten locking plate screw.
6. If outlet is on the left side of the unit.
Route power cord as shown in Figure D.
To replace front grille:
Hook the tabs on the front grille even with
the tabs on the case and snap into place.
Replace the screws and filter.
Refer to Page 4, Figure A.
VENT CONTROL AND AIR DIRECTION
(See Figure E)
The vent control is located behind the front
grille on the right side of the air discharge
area. When set at CLOSE only the air inside
the room will be circulated and conditioned.
When set at OPEN, some inside air is
exhausted outside.
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove the vent card, turn it over and
replace it by locating rear hole in card over
locating pin inside air discharge and
reattaching screw at front.
