13
Air Conditioner Features (continued)
Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any
fan speed you prefer, EXCEPT AUTO FAN. During this function, the display will show the actual current
temperature, not the set temperature as in the cooling mode.
Note: In this mode, the fan will continue to run for a short time after the compressor cycles off.
Note 1: For Delay Stop, the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour
increments up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the timer
remaining until start (8, 7.5, 7, etc.). After set Timer, the unit will enter into Timer mode by 5 seconds, then
Timer light on, Set light off. In Timer mode: Set temperature and fan speed keeps previously set temperature
and fan speed; Temperature display set temperature, no display if power turn off; Press Timer once, LED
display remaining time of set time, LED return to set temperature by 5 seconds; When in Fan Only mode, LED
only display room temperature, do not display set temperature. Turning the unit "ON" or "OFF" at any timer
will cancel the Delay Start/Stop function. The delay Start/Stop feature will work until the unit either starts or
stops. Once this has happened then the above steps have to be repeated again.
Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the
“Cool” Mode, the fan will run continuously while cool is needed. The temperature will automatically be
maintained anywhere between 61°F (16°C) and 86°F (30°C).
When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air.
If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a
Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.
Light on
