OPERATING PROCEDURES
LEVELING PROCEDURE
2. Turn ignition switch to "ACCESSORY".
3. Push the "ON/OFF" switch to the "ON" position.
The POWER ON light will be lit.
7. Push the "ON/OFF" switch to the "OFF" position.
8. Turn the ignition switch off.
6. After the vehicle is level, the jacks not used for leveling
may be extended until they touch the ground and lift the
vehicle slightly. This provides additional stability against
wind and activity in the vehicle. Do this by pushing the jack
control lever to the rear and/or front as needed to extend any
PARK/BRAKE" light will come on when the "ON/OFF"
switch is on. The pump will not run if the park brake
4. Move the FRONT and REAR STORE LEVERS to the OPERATE
POSITION. Nothing should happen at this time. Place pads
under jacks if necessary at this time.
1. Place gear selector in the parking position, apply the park
brake and block tires securely.
not have enough stroke to level the vehicle. The vehicle may
raise a low corner. If the ground is too uneven, the jacks may
take several movements from side to front, or side to rear to
jack pairs accordingly until all yellow lights are out. It may
extend jack pairs corresponding to a lit yellow light. Extend
Move the JACK CONTROL LEVER to the extend position to
should be lit at at a time. If a corner of the vehicle is low,
corner of the vehicle is low. Only one yellow LEVEL light
5. A lit yellow LEVEL light indicates that the end, side or
a side LEVEL light will be on by itself.
NOTE: If the hand/auto park brake is not set, the "NOT IN
NOTE: The respective red WARNING LIGHT will come
on when a jack is extended 1 or more inches.
have to be moved.
JACK
LEVER POSITIONS
CONTROL
LEVER
FRONT
STORE
LEVER
REAR
STORE
LEVER
LEFT
RIGHT
CAUTION!
UNDERSTAND OPERATOR’S MANUAL BEFORE USING.
BLOCK FRAME AND TIRES SECURELY BEFORE
REMOVING TIRES OR CRAWLING UNDER VEHICLE.
ON
OFF
EXTEND
REAR
REAR
OPERATE
FUSE
STORE
5 AMP
FRONT
STORE
HYDRAULIC LEVELING
ON
EXTEND
EXTEND
FRONT
HWH
NOT IN
EXTEND
PARK/
BRAKE
OPERATE
MP35.202J
19NOV07
OPERATE POSITION
is not set.
remaining jacks. Do not use the right or left extend positions.
GENERAL INSTRUCTIONS
Maintain adequate clearance in all
Site selection -
directions for vehicle, room extensions, awnings, doors,
steps, etc. Vehicle may move in any direction due to
jacks extending or retracting, settling of jacks or vehicle,
equipment malfunction, etc. If parking on soft ground
or asphalt paving, a wood block or pad should be placed
under each jack.
Read all room extension operating procedures before
before extending or retracting any room.
It is the operator’s responsibility to check that the jacks
are completely retracted and any room extensions are
completely retracted before moving the vehicle.
IMPORTANT: Do not use a room extension support
when the vehicle is supported by the leveling system.
NOTE: The "POWER ON" light must be on
to extend or retract a room.
Summary of Contents for 225 Series
Page 30: ......
