HWH 225 Series, Operator'S Manual

Page: 11 / 31

OPERATING PROCEDURES
ROOM RETRACT PROCEDURE
2. Turn the ignition switch to ACCESSORY.
3. Push the leveling system "ON/OFF" switch to "ON".
must be illuminated.
4. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted.
halt the operation of the room.
6. Push the leveling system "ON/OFF" switch to "OFF".
7. Turn the ignition switch off.
8. Engage all room-locking devices.
IMPORTANT: Room-locking devices should be locked
while traveling.
CAUTION:
CLEAR OF ROOM WHEN OPERATING.
KEEP PEOPLE AND OBSTRUCTIONS
9. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
NOTE: To operate the room, the POWER ON LIGHT NOTE: Releasing the ROOM CONTROL SWITCH will
HWH Customer Service for assistance 1-800-321-3494.
room. DO NOT reverse direction of the room, contact
room control switch immediately. DO NOT force the
If either side of the room stops moving, release the
after the room is fully retracted or stops moving.
in the "RETRACT" position for more than ten seconds
Do not hold the ROOM CONTROL SWITCH
reversed, DO NOT retract the room until the room
the room. If the direction of the room has been
of the room may be reversed, but watch for binding of
the room is fully retracted. If necessary, the direction
of the room, do not reverse direction of the room until
During normal operation
Hold the switch to "RETRACT" three or four seconds
after the room is fully retracted. This assures proper
has been fully extended.
pressurization of the cylinders.
IMPORTANT:
NOTE:
MP35.207J
13FEB04
1. The park brake must be set. The room will not operate
if the park brake is not set.
IMPORTANT: Extending or retracting any leveling
jacks when the room is extended is not recommended.
5. To extend the Travel Clamps, push and hold the
Travel Clamp control switch to LOCK until the Travel
Clamps are fully extended. The clamps will shut off
automatically when fully extended.
ROOMS WITH TRAVEL CLAMPS