PART III
MI35.2010
21JUN95
KICK DOWN JACKS:
A short hose is attached to the
jack at the factory. The hose is clamped to the pivot bracket.
It can be moved to the opposite side of the jack if necessary
to avoid heat sources or other obstacles.
ROLLER
BEARING
9000# KICK DOWN JACK
jack, the hose should go in the upper left-hand corner, over
the pivot area and down the front of the jack. After connect-
ing the hose to the fitting, the hose should be clamped with
a 1/4" bolt to the left side of the pivot bracket. Be sure the
hose is snug against the jack in the retracted (horizontal)
position.
Route the hose around the left
pivot, then across the back side of the cylinder and connect
to the actuator fitting. Attach the hose to the pivot bracket
using a hose clamp. There should be no slack in the hose.
- When connecting the hose to the
COMPONENT INSTALLATION
6000# KICK DOWN JACK-
16000# KICK DOWN JACK-
FIGURE 5
FIGURE 6
FIGURE 7