Damocles2
Ares LTE
31
Troubleshooting
Configuration SMS
•
GETCFG variable
– obtains the information about the value of a variable.
•
SETCFG variable
– sets the variable to a requested value.
Use
SETCFG variable = value
SETCFG variable = value; variable1 = value1;… (max. 160 chars)
GETCFG variable
SETCFG variable; variable1;… (max. 160 chars)
Example
SETCFG device_name=AresSms Test;gprs/gprs_apn=internet1;gprs/gprs_number=12345
SETCFG device_name=Ares12;gprs/gprs_apn=internet;gprs/gprs_number=*99***1#
GETCFG device_name;gprs/gprs_apn;gprs/gprs_number
Example
<?xml version=“1.0“ encoding=“utf-8“?>
<root>
<setup>
<host_name> Ares12</host_name> >>> SETCFG device_name=Ares12
<gprs>
<gprs_apn> internet </gprs_apn> >>> SETCFG gprs/gprs_apn=internet
</gprs>
</setup>
</root>
Names of variables are the same as the names in setup.xml within the <setup> section.
•
Modem does not respond
– check the information in the Modem Status field on the General tab:
•
SIM unplugged
– no SIM was found. Insert a SIM, or clean its contact pads.
•
Modem initializing...
– modem is being initialized. This information should not appear for more
than 10 s. Otherwise, it indicates a modem fault. If this message persists, check the SIM,
clean its contact pads if necessary, and press
Reset
to restart the unit.
•
Invalid PIN
– PIN code is not entered in the Ares LTE unit, or it is incorrect. Input the correct PIN
in
Advanced Config Mode
on the
GPRS/Internet
tab.
•
PUK requested
– PUK code is required (must be entered in a different kind of device). The SIM
is blocked until the correct PUK is entered. Take the SIM out and unblock it in a mobile phone.
•
Dialling...
– connection to the carrier is being dialed (necessary to establish GPRS connecti-
on). This information should not appear for more than 20 s. Otherwise, it indicates a modem
fault. Check the
Dial number
in
Advanced Config Mode
on the
GPRS/Internet
tab. When in doubt,
contact your mobile carrier.
Troubleshooting
Summary of Contents for Ares 10 LTE
Page 1: ...Ares 10 12 LTE User manual...