Ares LTE
12
•
Dialing...
– connection to the carrier is being dialed (necessary to establish GPRS connecti-
on). This information should not appear for more than 20 s. Otherwise, it indicates a modem
fault (see
Troubleshooting
).
•
Configuring Internet...
– internet connection is being configured (reading IP parameters).
•
Connected to Internet
– the modem is successfully connected to the internet.
•
Terminating Internet...
– internet connection is being disconnected.
•
Terminated
– connection to the mobile network was terminated. This can appear when the
device is being restarted, switched off, or when its battery is low.*
•
Hanging up...
– dial-up connection is being hanged up.
•
„-“
– unknown state.
•
Signal Quality
– GSM signal quality in dBm and as a percentage. The percentage should be as
high as possible. If it is less than 50 %, we strongly suggest to relocate the antenna or use
a different mobile carrier.
•
Reg. Operator
– regional GSM carrier. Indicates a successful connection to the GSM network,
and the actual carrier when roaming.
•
FW version
– current firmware version.
•
Email Queue
– number of outgoing e-mails waiting in the queue.
•
SMS Queue
– number of outgoing text messages waiting in the queue.
Digital Inputs ID 8 – External Power
System entry that indicates connected/disconnected external power supply. It is used to inform
about power failures and battery-powered operation.*
Sensors ID 65535 – Battery monitor
System entry that informs about the battery charge level.*
Note:
In case a backup power supply is needed for Ares 10 LTE we recommend the use of optional
accessory „UPS 12V“ (12V with 1,3 Ah capacity and power outage indication) or „UPS 12V + 5V“ (12V and
5V simultaneous use possible with 1,3 Ah capacity, one 1-Wire UNI output and power outage indication).
*Applies to Ares 12 LTE only.
Advanced settings
Summary of Contents for Ares 10 LTE
Page 1: ...Ares 10 12 LTE User manual...
