Hussmann Smart Exchange, Installation & Operation Manual

Page: 45 / 70

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
P/N 3110238_B 4-5
Smart Exchange Food Lockers
P/N 3034040_F 11
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
VRL Merchandisers
Hussmann Self-Contained Refrigeration Start - Up Check List
***Please note that failure to follow this start-up document may void your factory warranty***
Form HSCW01 Rev. 30MAY12 P/N 0525209_B
LEGAL DISCLAIMER:
Hussmann shall not be liable for any repair or replacements made without the written consent of Hussmann, or when the product is installed or operated in
a manner contrary to the printed instructions covering installation and service which accompanied such product.
Step Startup Activity Check
1
Locate, read and maintain install/operation manual in a safe place for
future reference.
2 Confirm there is NO damage or concealed damage .
3 Level the locker assembly , side to side and front to rear.
4 Remove all shipping brackets/compressor straps/bolts etc.
5
Refrigeration must be run on a dedicated electrical circuit without the
use of an extension cord.
6
Ensure that the proper electrical requirements for the locker
assembly are supplied.
7 Verify field electrical connections are tight.
8
Verify all electrical wiring is secured and clear of any sharp edges or
hot lines.
9 Verify the condensate drain line is properly trapped and pitched.
10 Verify all required clearances on the sides and back of locker assembly .
11
Verify there are no external air disturbances . Heat and air registers,
fans, and doors etc.
Advise owner/operator that merchandiser must operate at temperature for 24 hrs prior to
loading with product.