Hussmann Smart Exchange, Installation & Operation Manual

Page: 25 / 70

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
P/N 3110238_B 2-7
Smart Exchange Food Lockers
Adjusting the camera’s angle of view
1. Adjust the horizontal (PAN) angle by pinching
the side parts of the camera (A).
2. Adjust the azimuth (YAW) angle and vertical
(TILT) angle.
a. Loosen the TILT/YAW fixing screw
b. Adjust the azimuth (YAW) angle and verti-
cal (TILT) angle by pinching the outside
parts of the lens (B)
c. Fix each part by tightening the TILT/
YAW fixing screw.
REFRIGERATION STARTUP
The refrigeration can be started up at this time. Please refer to the Refrigeration Section (Sec. 4) of this
manual before starting up the condensing units of the locker assembly.
It is recommended to allow each refrigeration module to run to its control temperature cutout
setpoint before proceeding with canopy installation. This will allow installing contractor to more
easily address any refrigeration issues. See separate Technical Data Sheet (TDS) for refrigerant settings
and defrost requirements. Bring each refrigerated module down to it’s corresponding operating
temperature listed on the data sheet.
Each refrigerated module has its own evaporator coil and pre-set adjustable thermostatic expansion
valve (TXV). Evaporator super heat must be checked on each refrigeration system during startup.
The TXV has been factory set to provide the recommended performance settings as specified on
merchandiser data sheets. Only a certified technician should adjust these valves.