Elite
Medium Temperature
P/N 0453523
1-5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Join Plexiglass
Parts List
• Acrylic Solvent Cement (IPS Weldon #40 or
comparable, mixing instructions on product)
• Masking tape and duct tape (not supplied)
Instructions
1. Prepare front plexiglass for cement applica-
tion by placing masking tape not more than
1
/
16
in. (6 mm) from the seam, on both sides,
front and back. Tape is to protect plexiglass
from cement spill over. Scarring will occur if
cement touches clear plexiglass.
2. Separate front plexiglass pieces enough to
apply a bead of #40 cement down one edge
inside of seam.
3. Apply cement with applicator to one or both
surfaces.
Join immediately.
4. Realign front plexiglass and push together
tightly.
5. Apply just enough pressure to remove any air
bubbles. Do not squeeze joint so hard as to
force cement out of the joint—a dry joint may
result.
6. Apply tape (2 in. duct tape recommended)
across face of seam to secure plexiglass from
shifting while cement dries.
7. Allow approximately 4 hours to dry at 70°F.
Seal Merchandisers
1. Apply butyl tape across the bottom joint. Be
sure to extend the tape up the back and front
of the case.
2. Use field-supplied silicone to fill any gaps
between the front support brackets.
Butyl Tape
