Husqvarna SMS 125 2011, Workshop Manual

Page: 56 / 258

D.26
CR 125 2011 - WR 125 2011
H06718
1
2
H06719
1
2
H07068
H06720
3
SETTINGS AND ADJUSTMENTS
Workshop Manual Ed. 06-2011
Steering bearing clearance adjustment
For safety reasons, the steering should always be adjusted so that the handlebar
turns freely and without play. To check steering adjustment, set a stand or a block
under the engine and see that the front wheel is lifted from the ground. Press
lightly on the handlebar grips to cause the front end to rotate; the handlebar should
turn smoothly. Sit on the ground in front of the front wheel and hold the lower
ends of the fork legs. Push and pull in a front to rear motion to feel for play.
If any play is detected, adjust as follows:
- Loosen the steering head tube nut (1);
- loosen the two screws (3) securing steering head to fork legs;
- Turn the steering head tube ring nut (2) clockwise using the special key until
achieving correct play adjustment;
- Tighten the steering head tube nut (1) to 80÷90 Nm, 7÷9 Kgm, 59÷66,38 ft/
Ib;
- Tighten the two bolts (3) on the steering head to 22,5÷26,5 Nm, 2,3÷2,7 Kgm,
16,59÷19,55 ft/Ib.
Steering angle adjustment
Steering angle can be modified by means of the adjuster assemblies located on
either side of the steering head tube as follows: loosen the check nut (1), turn
the adjuster screw (2) until setting the desired steering angle and then re-tighten
the check nut (1). Make the same changes on both sides.