Husqvarna SMS 125 2011, Workshop Manual

Page: 36 / 258

D.6
CR 125 2011 - WR 125 2011
H06673
4
3
H06674
2
1
H06675
1
SETTINGS AND ADJUSTMENTS
Workshop Manual Ed. 06-2011
Throttle cable adjustment
The throttle cable can be adjusted using the screw set on the throttle, or using
the adjusting screw set on the
carburettor cover. To check for proper adjustment of throttle cable, proceed as
follows:
- remove rubber cap;
- move transmission sheath to and fro to ensure a play of approx. 1 mm;
- should play be greater than 1 mm, loosen lock nut (1) and register (2); should
play less than 1 mm, then tighten lock nut and register;
- if register (2) should not provide sufficient movement to allow for correct
adjustment, then adjust register placed on carburetor.
There should be approx. 1 mm play on latter register; should this not be the
case, then loosen lock nut (3), and loosen or tighten screw (4), to respectively
increase or decrease the play.
Operation with damaged throttle cable could result in an unsafe
riding condition.
Idle adjustment
Idling should be adjusted only when the engine is hot and throttle is closed, as
follows:
- turn the idle speed adjuster screw (1) until setting 1500 RPM ± 100 (turn clock-
wise to increase the speed and counter clockwise to reduce the speed).
Exhaust gas contains poisonous carbon monoxide gas. Never run
the engine in a closed area or in a confined area.