Husqvarna FC 450 2018, Repair Manual

Page: 193 / 335

ENGINE 17
Info
When pressing in, ensure that the section of the
engine case lies flat in order prevent damage.
Only press the bearings in using the outer bearing
race; otherwise, the bearings will be damaged when
they are pressed in.
After the section of the engine case has cooled, check that
the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it
is likely that they will rotate in the engine case when
warm. In this case, the engine case must be renewed.
Press in shaft seal ring
8
of the countershaft and shaft seal
ring
C,
of the shift shaft with the open side facing inward
until it is flush.
Position the bearing retainers.
Mount and tighten screws
@).
Guideline
Screw, bearing
retainer
MS
Position oil spray tube
8.
Mount and tighten screw
O.
Guideline
Screw, oil spray M4
tube
Mount the dowels.
6 Nm (4.4 lbf ft)
Loctite
®
243
™
5 Nm (3. 7 lbf ft)
Loctite ® 243
™
Blow compressed air through all oil channels and check that
they are clear.
...
17.4.3 oil pressure control valve, removing
•-e
8-<:)
<t>"'
0- 8
D01669-10
Remove screw plug
O
with sealing washer
8.
Remove pressure spring
@)
and ball
8.
191