Husqvarna F1103V5, Owner'S Manual

Page: 107 / 133

CLEANING, CARE 19
105
19.1 Cleaning the motorcycle
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
60 cm (23.6 in)
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Clean the motorcycle regularly to maintain its value and appearance over a long period.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
–
Close off exhaust system to keep water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray the heavily soiled parts with a normal commercial
motorcycle cleaner and clean using a brush.
Motorcycle cleaner ( p. 123)
Info
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to a dry motorcycle;
always rinse the vehicle with water first.
Clean the motorcycle with cold water if it has been
used on salted roads. Warm water enhances the cor-
rosive effects of salt.
–
After rinsing the motorcycle with a gentle spray of water,
allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the
brake system.
–
Brake carefully several times to dry out and
remove dirt from the brake linings and the brake
discs.
–
After cleaning, ride the vehicle a short distance until the
engine warms up.