Anti-scalp Rollers
Anti-scalp rollers are properly adjusted when they are just
slightly off of the ground when the deck is at the desired
cutting height in the operating position. Anti-scalp rollers then
keep the deck in the proper position to help prevent scalping
in most terrain conditions.
Anti-scalp rollers can be set in three positions:
• Upper position 1½ to 3" (38 to 76 mm) grass.
• Middle position 3" to 4½" (76 to 114 mm) grass.
• Lower position 4½" to 6" (114 to 152 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from ground.
Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION Adjust anti-scalp rollers with
the mower on a flat level surface.
To avoid deck damage, the anti-scalp rollers must not be
adjusted to support the deck.
V-belts
Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in normal
operation.
The belts are not adjustable. Replace belts if they begin to slip
from wear.
Deck Belt Removal
1. Park on a level surface. Apply park brake.
2. Lower the deck into the lowest cutting position.
3. Remove foot plate and belt shields.
4. Using a ratchet or breaker bar with a
9
/
16
" socket on the
spring idler bolt, relieve the tension on the belt.
5. Remove any dirt or grass that may have accumulated
around the cutter housings and entire deck surface.
6. Carefully lift the belt over the top of the cutter housing
pulleys.
Caster Wheels
Check every 200 hours. Check that wheels rotate freely. If
wheels do not rotate freely take the unit to your dealer for
service.
Foam filled tires or solid tires will void the warranty.
Removal and installation
Remove nut and caster bolt. Pull the wheel out of the yoke and
take care of the spacers. Install in reverse order. Tighten caster
bolt.
7. Remove the belt from around the electric clutch on the
engine shaft and off the mower deck.
Deck Belt Installation
NOTE: For ease in installing the deck belt, refer to the
routing decal on the top of the deck.
1. Wrap the deck belt around the electric clutch pulley that is
located on the engine shaft.
2. Route the belt forward between the spring loaded and
stationary pulleys.
3. Place belt around spring loaded idler pulley.
4. Wrap the belt around the stationary idler pulley and
around the mandrel housings.
5. Push inward on the idler arm and carefully route belt over
stationary idler pulley. Once belt is properly routed, slowly
release idler arm to tension belt.
6. Check that there are not twists in the belt and that the
routing
matches the routing decal.
7. Replace belt shields on both mandrel housings and
secure with fasteners.
25
MAINTENANCE
Summary of Contents for 967277502
Page 33: ...33 SCHEMATIC ...
Page 42: ...42 SERVICE JOURNAL Action Date mtr reading stamp sign ...
Page 43: ......
Page 44: ...www husqvarna com 115 666627 Rev A 2013 11 15 ...
