4. Raise the mower deck by pressing the foot pedal forward
to the transport position.
IMPORTANT INFORMATION Leaving the ignition switch
in any other position than OFF will cause the battery to be
discharged.
5. When the machine is standing still, activate the park brake
by pulling the lever upward.
If the engine has been worked hard, allow it to idle at
least 60 seconds to attain a normal operating temperature
before stopping. To prevent fouling the spark plugs, avoid
idling the engine for longer periods.
6. Turn the ignition key to the stop position.
7. Remove key. Always remove key when leaving the mower
to prevent unauthorized use.
WARNING! Never drive the rider on terrain that
slopes more than 10 degrees. Mow slopes up and down,
never side to side. Avoid sudden directional changes.
Operating on Hills
Read the Safety Instructions
Driving on Slopes
in the
Safety
Instructions
.
1. Use the slowest speed possible before starting up or
down hills.
2. Avoid stopping or changing speed on hills.
3. If stopping is absolutely necessary, pull drive levers into
the neutral position and push to the outside of the unit and
engage the park brake.
4. To restart movement, release the park brake.
5. Pull the control levers back to the center of the mower and
press forward to regain forward motion.
6. Make all turns slowly.
Mowing Tips
• Observe and flag rocks and other fixed objects to avoid
collisions.
• Begin with a high cutting height and reduce it until the
desired mowing result is attained. The average lawn should
be cut to 2½" (64 mm) during the cool season and over 3"
(76 mm) during the hot months. For healthier and better
looking lawns, mow often after moderate growth.
• For best cutting performance, grass over 6" (15 cm) in
height should be mowed twice. Make the first cut relatively
high; the second to the desired height.
• The finest lawns are obtained by mowing often. The lawn
becomes more even and the grass clippings more evenly
distributed over the mown area. The total time taken is not
increased as a higher operating speed can be used without
poor mowing results.
• Avoid mowing wet lawns. The mowing result is poorer
because the wheels sink into the soft lawn, clumps build,
and grass clippings fasten under the cowling.
• Hose the mower deck underside with water after each use.
When cleaning, the mower deck shall be raised into the
transport position. Make sure the mower is cooled and the
engine is off.
• Use compressed air to clean top surface of the deck.
Avoid flooding water on top surface, engine and electrical
components.
• When the mulching kit is used, it is important that the
mowing interval is frequent.
WARNING! Clear the lawn of stones and other
objects that can be thrown out by the blades.
19
OPERATION
Summary of Contents for 967277502
Page 33: ...33 SCHEMATIC ...
Page 42: ...42 SERVICE JOURNAL Action Date mtr reading stamp sign ...
Page 43: ......
Page 44: ...www husqvarna com 115 666627 Rev A 2013 11 15 ...
