Fuse
The 20 amp primary fuse is located on the left hand side of the
machine. It is accessed by tilting the seat forward. The fuse is
a flat pin type used in automobiles.
Fuel Shut Off Valve
The fuel shut off valve is located at the left rear of the seat. The
valve is off when the handle tab is turned perpendicular to the
fuel line.
Seat Adjustment Lever
The seat can be adjusted lengthways. When making
adjustments, the lever under the right side of the seat is pulled
up, after which the seat can be moved backward or forward.
Cutting Height Lever
IMPORTANT INFORMATION To obtain an even cutting
height, it is important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION Always raise the deck to the
highest position for transport.
To set the desired deck cutting height, press the release button
and move the lever forward to the correct cutting height on the
cutting plate. See
Before Starting
in the
Operation
section
to change the cutting height. The cutting height range is from
38 mm to 102 mm in 13 mm increments. The heights are
measured from the ground up to the blade tip with the engine
not running.
Bypass Linkages
WARNING! Bypass linkages are located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levers are
handled.
Transaxle bypass linkages must be engaged when pushing or
pulling the mower. The release levers are located on each side
of the rear of the unit below the rear engine plate. See
Moving
Machine By Hand
in the
Operation
section.
14
CoNTRolS
Summary of Contents for 967036502
Page 32: ...32 schematic ...
Page 39: ......
Page 40: ...www husqvarna com 115 681328 Rev A 2014 02 15 ...
