Moving Machine By Hand
When pushing or pulling the mower, engage the EZT bypass
linkages. The EZT bypass linkages are located on the rear of
the frame, below the rear engine guard.
1. Raise the deck into the highest cutting position.
2. Engage the park brake.
3. Pull the EZT bypass linkages up and out of the keyhole
slots. Release the levers with the head outside the frame
and held in the bypass position.
4. To reengage the EZT’s to drive, reverse the above
procedure.
WARNING! Use extreme caution when loading the
machine into a truck or trailer using ramps. There is the
possibility of serious injury or death if the machine falls off
the ramps.
1
2
WARNING! Make no adjustments without:
•
the engine stopped,
•
the ignition key removed,
•
the park brake activated
WARNING! Bypass linkages are located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levers are
handled.
Load the machine into truck or trailer by driving slowly up the
ramps. DO NOT LIFT! The machine is not intended to be lifted
by hand.
21
oPERATIoN
Summary of Contents for 967036502
Page 32: ...32 schematic ...
Page 39: ......
Page 40: ...www husqvarna com 115 681328 Rev A 2014 02 15 ...
