Husqvarna 967036502, Operator'S Manual

Page: 20 / 40

Mowing Tips
• Observe and flag rocks and other fixed objects to avoid
collisions.
• Begin with a high cutting height and reduce it until the
desired mowing result is attained. The average lawn should
be cut to 64 mm during the cool season and over 76 mm
during the hot months. For healthier and better looking
lawns, mow often after moderate growth. For best cutting
performance, grass over 15 cm in height should be mowed
twice. Make the first cut relatively high, the second to the
desired height.
• The mowing result will be best with a high engine speed
(blades rotate rapidly) and low speed (rider moves slowly).
If the grass is not too long and dense, the driving speed
can be increased without negatively affecting the mowing
result.
• The finest lawns are obtained by mowing often. The lawn
becomes more even and the grass clippings more evenly
distributed over the mown area. The total time taken is not
increased as a higher operating speed can be used without
poor mowing results.
• Avoid mowing wet lawns. The mowing result is poorer
because the wheels sink into the soft lawn, clumps build,
and grass clippings fasten under the cowling.
• Hose the mower deck underside with water after each use.
When cleaning, the mower deck shall be raised into the
transport position. Make sure the mower is cooled and the
engine is off.
• Use compressed air to clean top surface of the deck.
Avoid flooding water on top surface, engine and electrical
components.
• When the mulching kit is used, it is important that the
mowing interval is frequent.
IMPORTANT INFORMATION The mower is equipped
with a 12-volt negative grounded system. The other vehicle
must also be a 12-volt negative grounded system. Do not
use your mower to start other vehicles.
CAUTION! lead-acid batteries generate explosive
gases. Keep sparks, flame and smoking materials away
from batteries. Always wear eye protection when around
batteries.
Weak Battery
If the battery is too weak to start the engine, it should be
recharged. (See
Battery
in the
Maintenance
section.)
If jumper cables are used for emergency starting, follow this
procedure:
Jumper Cable Use
1. Connect each end of the RED cable to the POSITIVE (+)
terminal on each battery, taking care not to short against
chassis.
2. Connect one end of the BLACK cable to the NEGATIVE (-)
terminal of the fully charged battery.
3. Connect the other end of the BLACK cable to a good
CHASSIS GROUND on the mower with the discharged
battery, away from the fuel tank and battery.
To remove cables, reverse order
1. Remove BLACK cable first from chassis and then from the
fully charged battery.
2. Remove RED cable last from both batteries.
20
oPERATIoN