10:2
B
C
A
D
CLEANING THE MACHINE
To keep your sewing machine operating well, clean it often.
No
lubrication (oiling) is needed.
Wipe the exterior surface of your machine with a soft cloth to
remove any dust or lint build up.
Wipe the touch screen with the microfiber cloth included with
your machine.
Cleaning the Bobbin Area
Note: Lower the feed teeth and turn off the machine
(see page 2:10).
Remove the presser foot and slide off the bobbin cover.
Lower the feed teeth. Place the screwdriver under the needle
plate as shown in the picture and gently turn the screwdriver
to pop off the needle plate. Clean the feed teeth with the
brush found with the accessories.
Cleaning under the Bobbin Area
Clean the area under the bobbin case after sewing several
projects or any time you notice an accumulation of lint in the
bobbin case area.
Remove the
bobbin case holder (A) covering the front part of
the bobbin case by lifting it up. Remove the bobbin case (B)
by lifting it up. Clean with the brush.
Note: Use caution when cleaning around the Selective Thread
Cutter knife (C).
Put the bobbin case and the bobbin case holder back in place.
Note: Do not blow air into the bobbin case area. The dust and lint will
be blown into your machine.
Note: When using the optional accessory HUSQVARNA VIKING
®
Embroidery Cutwork Needles, it is neccessary to clean the bobbin area
after each embroidered design/project.
Replacing the Needle Plate
With feed teeth lowered, place the needle plate so that it fits
into the notch at the back (D). Press the needle plate down
until it clicks into place. Slide on bobbin cover.
