E
mbroidEry
S
titch
-o
ut
8:9
EMBROIDERY STITCH-OUT POP-UP
MESSAGES
Embroidery Unit Calibration
When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine area for
calibrating the embroidery arm. You will also be reminded to
attach the correct embroidery foot.
Note: It is very important to remove the hoop, otherwise the hoop or the
embroidery unit may be damaged while calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does not
match the size displayed on screen, the machine cannot
embroider. You must change the hoop to the hoop size
displayed in the pop-up or change the hoop setting.
To change hoop settings, return to Embroidery Edit and
touch My Hoops icon.
Cut Thread End
When Automatic Jump Stitch Trim is selected in the SET
menu, the thread end will be cut automatically. Simply remove
the thread tail that has been cut.
Note: After changing the thread, the machine will sew a few stitches and
then stop so you can cut the thread end.
Bobbin Thread Low - move to bobbin position?
When the bobbin thread is running low, a pop-up message
appears giving you an advanced notice that you’ll soon need
to change the bobbin. This gives you an opportunity to
plan when you want to change your bobbin. If you want to
continue embroidering just touch the Start/Stop button or the
foot control without touching the ok in the pop-up.
It is possible to embroider until the thread has completely run
out. Press the start/stop button to continue embroidering
without closing the bobbin thread low pop-up.
Touch cancel to remain at the current stitch position. Touch
OK to move the hoop to bobbin position. The hoop position
pop-up opens. Replace the empty bobbin with a full one.
Touch Current position and pull back excess needle thread.
Press start/stop or press your foot control to continue
embroidering.
