Husky HU80722, Operator'S Manual

Page: 13 / 22

13
OPERATION
APPLICATIONS
You may use this tool for the purposes listed below:

Removing dirt and mold from decks, cement patios, and
house siding

Cleaning cars, boats, motorcycles, outdoor furniture, and
grills
STARTING AND STOPPING THE PRESSURE
WASHER
See Figures 11 - 12.
CAUTION:
Do not run the pump without the water supply connected
and turned on.
Before starting the engine:

Connect all hoses.

Check all fluids (lubricant and gas).

Turn on the garden hose then squeeze the trigger to
relieve air pressure; hold the trigger until a steady stream
of water appears.
To start the engine:
 Turn the fuel valve to the ON position.
 Put the engine switch in the ON position.

Pull choke.

Grasp the recoil starter and pull slowly until resistance is
felt. Give the recoil starter a short, brisk pull to start the
engine.
NOTE: Do not allow the recoil starter to snap back after
starting; return it gently to its original place.

Let engine run for several seconds, then push choke in.
To stop the engine:
 Put the engine switch in the OFF position.

Turn the fuel valve to the OFF position.
Fig. 1
Fig. 11
RECoIL
sTARTER
ENGINE swITCH
CHoKE
fuEL vALvE
sTART
RuN
off
oN