Husky HU80722, Operator'S Manual

Page: 9 / 22

9
ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
To attach the wheels to the pressure washer base:
 Locate the axle, hitch pins, washers, and wheels. Remove
the hitch pin from the axle.

Slide the axle through the hole in the center of the
wheel.

Slide the washer onto the axle.

Lift the machine and slide the axle into the wheel mount-
ing hole in the machine base as shown.

Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.

Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 3.
To install the handle:

Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the handle
in place.
Fig.
HITCH
PIN
AXLE
Fig. 3
PusH To
INsERT
wHEEL
wAsHER