Husky HU80722, Operator'S Manual

Page: 14 / 22

14
OPERATION
Fig. 13
USING THE SPRAY WAND TRIGGER
See Figure 13.
For greater control and safety, keep both hands on the
trigger handle at all times.

Pull back and hold the trigger to operate the pressure
washer.

Release the trigger to stop the flow of water through the
nozzle.
To engage the lock out:

Push up on the lock out until it clicks into the slot.
To disengage the lock out:
 Push the lock out down and into its original position.
For the most effective cleaning, the spray nozzle should be
between 8 in. and 4 in. from the surface to be cleaned. If
the spray is too close it can damage the cleaning surface.
SELECTING THE RIGHT QUICK-CONNECT
NOZZLE FOR THE JOB
See Figure 14 - 15.
Before starting any cleaning job, determine the best nozzle
for the job. Each of the nozzles has a different spray
pattern. The nozzle patterns are: 25˚ (for general purpose
or large surfaces), 15˚ (for tough jobs), 0˚ (for spot cleaning
or high-to-reach areas), and the Soap Blaster™ nozzle (for
long and short range detergent application).
 WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and NEVER point the wand at your
face or at others. The quick-connect feature contains
small springs that could eject the nozzle with some force.
Failure to heed this may cause personal injury.
Using the quick-connect collar, changing nozzles is easy.

Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
To connect a nozzle to the trigger handle:

Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.

Push the nozzle into the quick-connect collar until it clicks
in place and is secured properly.
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.

Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.

Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle storage area on the top of the machine.
Fig. 14
sLoT
NozzLE
QuICK-CoNNECT
CoLLAR
sPRAY
wAND
TRIGGER
Fig. 15
“CLICK”
LoCK ouT
LoNG RANGE
DETERGENT
APPLICATIoN
sHoRT RANGE
DETERGENT
APPLICATIoN
soAP
bLAsTER™