Husky HU80722, Operator'S Manual

Page: 11 / 22

11
ASSEMBLY
ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the injection
hose must be attached.

Open the cap from the detergent container.

From the top of the cap, slide the injection hose through
the hole in the cap.

Push the injection hose filter onto the end of the injec-
tion hose and pull enough hose through the cap so the
injection hose filter will rest at the bottom of the detergent
container (or detergent bottle).

Close the cap on the detergent container.

Push the open end of the clear injection hose securely
over the fitting as shown in figure 6.
NOTE: Keep injection hose away from hot surfaces by push-
ing the hose into the clip in the frame.
ASSEMBLING THE TRIGGER HANDLE
See Figure 7.
To attach the spray wand:

Place the threaded end of the spray wand in the connector
on the end of the trigger handle.

Turn the connector clockwise until it stops. This secures
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 8.
 Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.

Pull on the hose to be certain it is properly secured.
Fig. 7
Fig. 8
sPRAY
wAND
CoNNECToR
TRIGGER
HANDLE
INjECTIoN
HosE
fITTING
Fig. 6
INLET
CouPLER
HIGH PREssuRE
HosE
CoLLAR
INjECTIoN
HosE
CAP
CLIP
INjECTIoN
HosE fILTER