HURAKAN HKN-C1, Manual, Page: 13 / 46

EN
13
1. Specifications
Model HKN-C1 HKN-C2 HKN-C2-T HKN-C3
Overal dimensions,
mm
520x520x500 520x520x500 520x945x890 730x730x500
Bowl diameter, mm 520 520 520 730
Body color orange pink pink orange
Availability of a bogy no no yes no
Capacity, kg/h 2.8 2.8 2.8 2.8
Heating power, kW 0.9 0.9 0.9 0.9
Motor power, kW 0,08 0,08 0,08 0,08
Voltage 220-240V 220-240V 220-240V 220-240V
Frequency 50Hz 50Hz 50Hz 50Hz
Options not included in the scope of supply:
A cap for HURAKAN HKN-PC530C/HKN-PC730C candy floss machine.
Sticks for candy floss and hot dogs HURAKAN HKN-STICK.
Accessories HKN-PC530C HKN-PC730C HKN-STICK
Overal dimensions,
mm
520x520x435
730x730x435 3x300
Suitable for models HKN-C1, HKN-
C2, HKN-C2-T HKN-C3 All models
Material Plexiglass Plexiglass Bamboo
The manufacturer reserves the right to change the appearance and design of the candy floss
machine to improve its performance without changing the technical specifications.
2. Installation and preparation for work
• Attention! All installation and commissioning works must be carried out by qualified
technical personnel having a special permit in accordance with the regulations of the country
where this machine is used.
• Make sure that the mains voltage corresponds to the machine operating voltage, check the
installation of the protection devices and their compliance with their rating in terms of power
and characteristics.
• Protection devices must be located in the immediate v icinity of the machine or in the
switchboard if it is in direct access. The socket must meet the safety requirements and have a
reliable grounding.
• The machine should be installed on a fireproof surface.
• Electrical wiring must be and correspond to the rated power of the machine. Non-
compliance may result in fire.
• When transporting the machine, the fastening of parts, electrical connections and moving
mechanisms may weaken, therefore, they should be checked before the first start.
• Before the first us e, be sure to check the fastening of the spinner on the shaft. To do this, it
is necessary to remove the decorative semicircular grates, then install a lever, for example, a