29
MANUAL SINGLE
STATION
Manually Run A Single Station
1. Turn the dial to the
MANUAL-
SINGLE STATION
position.
2. Station run time will flash in
the display. Use the button
to move to the desired station.
You may then use the
and buttons to select the
amount of time for a station
to water.
3. Turn the dial to the
RUN
position to run the station
(only the designated station
will water, then controller will return to automatic mode with no
change in the previously set program).
MANUAL ALL
STATION
Manually Run All Stations
1. Turn the dial to
MANUAL-ALL
STATIONS
.
2. You can select program
A
,
B
,
C
, or
D
by pressing the
button.
3. Press the button until
desired starting station is
displayed.
4. Station run time will flash in
the display. Use the and
buttons to select the amount of run time for the station to water
if different from the run time displayed.
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to program
A
. You can select
program
B
,
C
or
D
by pressing the
button.
3. The station number will be flashing. Press the or button to
scroll through the stations and use the
and buttons to adjust
the station run times. (If no buttons are pressed during step 2 or 3,
the controller will automatically begin program
A
.)
4. Press the button to scroll to the station you wish to begin with.
After a 2 second pause, the program will begin.
This feature is great for a quick cycle when extra watering is needed or
if you would like to scroll through the stations to inspect your system.
5. Use the button to move to the next station.
6. Repeat steps 3 and 4 to customize each station if desired.
7. Press the button until desired starting station is displayed.
8. Return the dial to
RUN
(custom program will water the entire
program beginning with the station number last left in the display,
then controller will return to automatic mode with no change in the
previously set program).
NOTE:
The station that is on the display when you
turn the dial to
RUN
, will be the first station to run.
The controller will then proceed to water in
sequential order only. It will not water previous
stations. Example: If you turn the dial to RUN with
the display reading station 3, the controller will
water Stations 3 through 9 in the program, but not
return to Stations 1 and 2.
