Hunter G835, Owner'S Manual

Page: 37 / 58

to install the inlet valve into the rotor’s body, first load the white lower snap ring to the tool. Hold the white lower
snap ring in the palm of one hand with the raised protruding ends of the snap ring facing towards you (fig 103). In the
other hand hold the g800 Valve tool with the metal hook end of the tool pointing towards you. compress the snap
ring and place onto the tool so that the two metal roll-pins at the bottom of the black plastic part of the tool hold and
retain the white lower snap ring (fig 104).
With the white lower snap ring loaded to the underside of the g800 Valve tool, load the inlet valve to the tool. to do
so, hold the inlet valve in one hand with its top facing toward you (fig 105). rotate the inlet valve in your hand so that
the communication port (located on the side of the inlet valve) is at the 12:00 position while holding it in your hand. In
the other hand, hold the g800 Valve tool by the handle. the tool needs to be held so that the pointer arrow (located
at of one of the three screws on top of the tool) is also oriented to the 12:00 position.
next, slightly rotate the tool counter-clockwise to the 11:30 position. this alignment will allow the two metal hooks
on the g800 Valve tool to pass through the two correct openings around the outside of the inlet valve. press the
metal hooks through the openings. continue pressing the inlet valve and g800 Valve tool together compressing the
spring on the tool (fig 106). While holding the tool down with the spring compressed, turn the tool’s handle clockwise
until it stops. next, release the spring’s compression by lifting the handle slightly on the g800 Valve tool. this action
hooks and locks the inlet valve to the tool. check to make sure that the pointer arrow on the tool is directly above the
communication port on the inlet valve and that the valve is securely hooked to the tool.
FIg 103
FIg 105
FIg 104
FIg 106
Fig 102 Fig 103
Fig 104 Fig 105
Fig 104 Fig 105
Fig 102 Fig 103
34